Service Agreement
Smart homeowners agree – it’s cheaper to prevent a problem than to fix one. A Maintenance Service Agreement gives you the security of knowing that your HVAC system is always in prime working condition – and that you are covered if any sudden problems arise.
2 service visits per year (Fall & Spring)
Priority repair service
15% discount on repair work
Chances are, your heating and cooling system is the most important (and expensive) piece of machinery in your home. In fact, it’s probably also the largest consumer of energy! For such an important piece of equipment, an HVAC unit often doesn’t receive the regular attention that it needs to operate properly. When that happens, the expense of repair and replacement can become overwhelming.

A bi-annual checkup of your unit can eliminate the most common preventable problems before they have a chance to take a bite out of your budget. However, even the best maintenance can’t prevent all problems from occurring. That’s why we automatically give service priority to customers with Maintenance Service Agreement, along with a 15% discount on all repair work.

A Standard Maintenance Service Agreement Includes the Following
Heating Cycle Check
Calibrate and adjust thermostat
Test safety controls
Clean burners for efficiency
Calibrate gas valve
Check defrost controls (if applicable)
Lubricate all moving parts (if applicable)
Check and tighten all wiring connections
Check, clean or replace standard 1” filter(s)
Check for gas leaks in furnace
Inspect flue pipe for obstruction
Inspect heat exchanger for rust or cracking
Turn exposed dampers to heating position, if marked (no balancing)
Adjust pressure regulator
Check that crankcase heater is operating (if applicable)
Check ignitor operation
Cooling Cycle Check
Check refrigerant operating pressures
Check voltage and amperage to all motors with meter
Check air temperature drop across evaporator coil
Check start and run capacitors for proper voltage
Check evaporator superheat or subcooling
Lubricate all moving parts (if applicable)
Purge/Clean condensate drain line (No warranty)
Check, clean or replace standard 1” filter(s)
Check pressure switch cut-out settings
Check electrical lock out circuits
Check and clean contactors
Check all wiring and connections
Calibrate thermostat
Clean out primary and emergency drain pans (No warranty)
Turn exposed dampers to cooling position, if marked (No balancing).
*Chemical cleaning of the coil extra.

Remember, your system will get all this attention… twice a year!

In the long run, a Maintenance Service Agreement will cost only a fraction of the price of the service visits and replacements that could have been prevented. You change the oil in your car; you run anti-virus programs on your computer… and likewise, you should take basic measures to ensure the long-term health of your heating and cooling system.